How many gallons of transmission fluid does an Allison Transmission take?

2 Gallons of Allison Transynd synthetic fluid- (We have found this fluid to be far superior to anything else available.) It is completely compatible with Dexron 3 and Dexron 6 designed specifically for the Allison transmission. 1 genuine Allison spin on transmission filter.

How many quarts of fluid does an Allison Transmission take?

Allison 3000 transmissions can hold approximately 29 quarts of fluid; the larger Allison 4000 can hold approximately 48 quarts.

How much oil does a Allison 2000 hold?

7.4 quarts (includes the pint for the spin-on) for the stock (shallow) pan – all you can drain.

How much transmission fluid does a Allison 1000 hold?

Fluid and filter change will hold about 7.5 qts.

What transmission fluid does an Allison Transmission take?

Allison Transmission TES 295® Approved Fluids are approved for use in Allison 1000 Series™, 2000 Series™, 3000 Series™, 4000 Series™ and H 40/50 EP™ on-highway products. Allison recommends that customers using TES 295® Approved Fluid consider Allison’s newest fluid spec, TES 668®, for their next service.

What kind of transmission fluid does a DuraMAX Allison Transmission take?

tes 295 automatic transmission fluid
allison transmission recommends that customers use an allison approved tes 295 automatic transmission fluid to extend drain intervals and to enhance transmission performance and durability in all operating environments.

How many quarts does an Allison Deep Pan hold?

Allison gives 10.6 quarts for a refill.

How much fluid does a transmission take?

In general, transmissions take about 9 to 13 quarts to fill completely. The amount of transmission you add will vary, depending on whether you are draining or replacing it all or you are just topping it up. Again, you should avoid adding too much.

Can you put ATF in a Allison Transmission?

Mobil Delvac Syn ATF for Allison 1000 Especially this transmission fluid is also approved by Allison since it is approved against the Allison TES-295 specifications.

Is TranSynd compatible with dexron III?

Castrol TranSynd can be recommended for all vehicles calling for Dexron III/Mercon or Allison TES 295 and TES 468 ATF’s suitable for bus and refuse vehicles with automatic transmissions.

What type of transmission fluid does Allison use?

However, Allison allows an extended service interval when using an approved TES-295 fluid. Allison Service Tip #1099B lists the recommended fluid and filter change intervals when using a standard fluid, a mix of standard fluid and TES-295, and only TES-295.

What is the best brand of transmission fluid?

– Genuine Honda Transmission – Honda DW-1 Automatic Transmission Fluid, 1 quart, Pack of 4 – Its wide viscosity range provides outstanding protection

What are typical problems of an Allison Transmission?

Vehicle Stuck in Limp Mode The 6-speed transmission system from Allison is one of their most popular lineups.

Check Installation If you are someone who has changed the transmission system on their vehicle. Then there is a high chance that it might not work properly for you.

System Might Be Faulty

What is the best manual transmission fluid?